# Setting up a tarp over or under a tent

Learn how to rig a tarp above a tent for rain cover and lay one beneath it for ground protection, with pitching steps, clearance tips and tie-out details.

A tarp over a tent gives you a rain shield that keeps the tent body and door area drier. A tarp under a tent works as a groundsheet or footprint that shields the tent floor from grit, moisture and abrasion. The two setups use the same sheet of material but need different pitching, clearance and tie-out choices. 

- Pitch an overhead tarp high enough that it clears the tent peak, and angle it so water runs off one side.
- Keep the overhead tarp wider than the tent so drips land outside the walls rather than on the fabric.
- A tarp under the tent should sit fully inside the tent floor outline so it cannot collect rain.
- Tie every tarp corner to a separate anchor and keep guy lines taut but not rigid.
- Check overhead lines and stakes before you leave the site so nothing is left to trip another visitor.
 

## Choosing the right tarp size 

The overhead tarp needs to be larger than the tent footprint on every side, so runoff falls beyond the walls. Measure the tent length and width at ground level, then add extra margin on each side for the angled pitch. A tarp that only matches the tent leaves the door and corners exposed. 

The under-tent tarp, often called a footprint or groundsheet, should be slightly smaller than the tent floor. Extra material sticking out beyond the walls catches rain and channels it under the tent. Trim or fold the edges so the sheet stays inside the outline. 

Material weight matters for both jobs, because a light sheet packs small but a heavier sheet resists wind and wear. Check the grommets, which are the reinforced eyelets at the corners and edges, before you commit to a pitch. A torn grommet will pull out under tension. 

- Overhead tarp: wider and longer than the tent footprint
- Under-tent tarp: slightly smaller than the tent floor
- Reinforced grommets at corners and edge points
- Rope or cord long enough for each tie-out
 

## Pitching a tarp above the tent 

Setting up a tarp over a tent starts with choosing two or four anchor points, such as trees or stakes, that sit outside the tent area. Tie one end of a cord to each corner grommet and run it to the anchor. Raise the sheet before you tension it, so the fabric sits above the tent peak. 

The overhead tarp should slope from a high edge to a lower edge, which lets rain run off one side instead of pooling in the middle. Keep the low edge away from the door so water does not drip onto the entrance. A shallow slope sheds water more slowly than a steep one. 

Tent guy lines and tarp lines can share anchors, but each line needs its own tie so tension on one does not pull the other. Walk around the pitch and check that the tarp does not touch the tent fabric. Contact points rub and pass moisture through. 
| Pitch choice | Effect on rain cover | Effect on airflow | 
| Flat sheet above peak | Water can pool in the middle | Open sides let air move | 
| Sloped sheet, high side to windward | Water runs off the low edge | Airflow reduced on the high side | 
| A-frame ridge over the tent | Sheds water to both sides | Air passes under the open ends |  

## Setting a tarp under the tent 

How to set up a tarp under tent begins with clearing the ground of stones, roots and sharp debris. Spread the sheet flat and fold any overhang inward so the tarp stays inside the tent floor outline. Set the tent on top and stake the tent as you normally would. 

A tarp under tent for ground protection keeps the tent floor away from damp soil and abrasive grit. The sheet also makes cleanup easier, because you can shake it out before packing. Keep the tarp edges tucked under so rain cannot run onto the sheet. 

Some campers clip the under-tarp to the tent corners to stop it shifting during setup. Check that the clips do not pierce the tent floor and that the sheet lies smooth. A wrinkled tarp creates pressure points under the floor. 

- Clear the ground of sharp objects first
- Fold overhang inward, under the tent floor
- Lay the sheet smooth before the tent goes down
- Tuck edges so rain cannot run underneath
 

## Getting clearance above the tent 

Tarp clearance above tent means the gap between the sheet and the tent roof, and that gap keeps fabric from rubbing. Aim for a visible gap at the peak and along the ridge line. Check clearance again after the tarp has been tensioned and the tent has settled. 

A tarp pitched too low traps condensation and blocks the tent vents. Moisture gathers on the underside and drips onto the tent body. Raising the high edge and opening the sides improves airflow under the sheet. 

Wind changes the clearance as lines stretch and anchors shift. Retension the tarp lines after gusts and before you sleep. Loose fabric that slaps the tent wears both surfaces. 

## Tie-outs, stakes and wind 

Tarp guy lines carry the load from the sheet to the ground or to trees, so each line needs a secure knot and a firm anchor. Angle stakes away from the tarp so the pull seats them deeper. Use a stake long enough for the soil you are pitching on. 

Tension the lines until the sheet is firm but still able to flex in a gust. Lines pulled rigid transfer sudden loads to the grommets. A little give protects the tarp and the anchors. 

Tree trunks work as anchors only when you protect the bark, for example with a wide strap rather than a thin cord. Avoid tying to branches that move in wind. Check local site rules before you attach anything to trees. 

## Rain cover and ventilation together 

A tarp over tent for rain works only when water has a clear path away from the tent. Slope the sheet and keep the low edge clear of the door and the ground. Water that runs onto the tent walls still reaches the floor. 

Ventilation matters as much as cover, because a sealed tarp traps humid air. Leave the sides open where wind and rain allow, and keep the tent vents unobstructed. A tarp that covers the whole tent on all sides creates a damp pocket. 

A rain fly on the tent and an overhead tarp can work together, but the two layers should not touch. Separate layers shed water independently and dry faster. Check the gap between fly and tarp after pitching. 

## Leaving the site tidy 

Take down the overhead tarp before the tent when wind is rising, so the sheet cannot pull on the tent. Loosen lines gradually and fold the tarp dry where possible. Damp fabric stored in a pack develops mildew. 

Count every stake, cord and clip as you remove them. Small items left on grass become hazards for other park users and for mowers. Walk the pitch area once more before you go. 

Store the tarp loosely so folds do not crack the coating over time. Check the grommets and seams before the next outing. Repair small damage before it spreads. 

## Questions about tarp and tent setups 

### How do I put up a tarp over a tent? 

Putting up a tarp over a tent means anchoring the sheet above the tent peak and sloping it so water runs off one side. Tie each corner grommet to a separate anchor outside the tent area. Raise the sheet before tensioning so it clears the tent roof. 

### How do I set up a tarp under a tent? 

Setting up a tarp under a tent starts with clearing sharp debris from the ground. Spread the sheet and fold any overhang inward so it stays inside the tent floor outline. Pitch the tent on top and stake it as usual. 

### Should the tarp under a tent be larger than the tent floor? 

A tarp under a tent should be slightly smaller than the tent floor, not larger. Extra material beyond the walls catches rain and sends it under the tent. Fold or trim the edges so the sheet stays within the outline. 

### How much clearance does a tarp need above a tent? 

Tarp clearance above tent should leave a visible gap at the peak and along the ridge. The gap keeps the two fabrics from rubbing and lets air move between them. Check clearance again after tensioning the lines. 

### Will a tarp over a tent keep the inside dry in rain? 

A tarp over a tent sheds rain when it is sloped and sized wider than the tent. Water still reaches the tent if the sheet touches the walls or if the low edge sits over the door. Keep the sides open enough to let humid air escape. 

### Can I tie a tarp to trees over my tent? 

Tying a tarp to trees is possible when you use a wide strap that protects the bark. Thin cord cuts into bark and can damage the tree. Check site rules before attaching anything to trees.
